Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
7. Loosen the front brake line at the master cylinder to purge all the air from the cylinder.
8. Tighten the brake line as in Step 5, and then release the brake pedal slowly. Wait 15 seconds before proceeding to the next step.
9. Repeat the sequence, including the 15-second wait, until all the air is removed from the master cylinder bore.
NOTICE: Care must be taken to prevent master cylinder fluid from contacting any painted surface to prevent damage to the paint finish.
10. After all the air has been removed at the forward connections, bleed the master cylinder at the rear (cowl) connections in the same manner as with
the front connections.
IMPORTANT: For vehicles equipped with a non-Antilock Braking System (non-ABS), the bleeding sequence is as follows: right rear, left front,
left rear, and right front. For ABS-equipped vehicles, refer to Models With ABS Only.
11. Attach a transparent tube over the valve. Allow the tube to hang submerged in the master cylinder fluid in a transparent container.
12. Slowly push and hold the brake pedal one time.
