Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8.
Remove the Fuel Level Sensor by prying it in the same direction from the same retaining rail that previously held the Low Fuel Sensor Bracket.
Installation
9.
Temporarily wrap the new Fuel Level Sensor wire terminals with electrical tape.
10.
Route the wire through the groove at the bottom of the Fuel Level Sensor as you route it around to the back of the Fuel Level Sensor Body.
Note:
Failure to propertly mute the Wire in the remote may cause the wire to be damaged as the Fuel Level Sensor is installed.
11.
Guide the Fuel Level Sensor Body onto the retaining rail on the Fuel Pump Module Body. Slide it fully into place on the retaining rail. An audible
"click" will be heard as it locks into it's proper position.
Note:
Failure to properly lock the Fuel Level Sensor into place will affect its accuracy.
12.
Route the Fuel Level Sensor wires through the built-in tube in the Fuel Pump Module Body.
