Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
CAUTION:
Removing components from a sealed fuel system exposes fuel vapors to outside oxygen and possible sources of combustion. A fuel system should
only be opened in a properly ventilated area. Special caution should be used when removing components from a fuel tank or fuel system. Removal of
such components should only be done away from open flame (torches, lit cigarettes, heater pilots or other flames however minor) or sparks
(mechanical, electrical or otherwise) that could cause fuel vapors to ignite.
20.
Using a suitable hammer and brass drift, reinstall the Fuel Pump Module Retaining Ring by rotating it clockwise until it reaches it's stops.
21.
Reconnect the wiring Harness Connector to the Mounting Flange Connector on the Fuel Pump Module.
22.
Reinstall the Fuel Pump Outlet Hose by pushing it firmly into place. An audible "click" will be heard when the hose is properly connected.
23.
Reinstall the Fuel Tank Return Hose by pushing it firmly into place. An audible "click" will be heard when the hose is properly connected.
24.
Reinstall the Fuel Pump Relay into the Engine Compartment Fuel/Relay Box.
25.
Turn the Ignition Switch to the "ON" position and verify that the Fuel Pump operates for approximately 3 seconds by listening for pump motor
operation, then check the Fuel Pump Module for leaks.
26.
Road test the vehicle, then recheck the area around the Fuel Pump Module for fuel leaks.
27.
Reinstall the Fuel Pump Module Access Cover by pressing it into place.
28.
Reinstall the rear seat cushion.
Lanos ONLY - Reinstall the Rear Seat Cushion retaining bolt removed previously.
