Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
1. Install the front wheel speed sensor jumper harness. Route the harness through the body and secure the grommet.
2. Connect the front wheel speed sensor electrical connector.
3. Lower the vehicle.
4. Replace the jumper harness into the wiring harness and route it through the firewall into the vehicle interior at the Electronic Brake Control
Module (EBCM).
5. Insert the terminals into connector J1 as they had been removed:
-
Right side: terminals B3 (BRN) and A4 (DK GRN).
-
Left side: terminals B4 (YEL) and A5 (LT BLU).
6. Connect the EBCM connector J1.
7. Replace the Electronic Brake Control Module (EBCM) into its mounting.
8. Connect the negative battery cable.
