Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
21.
Slowly move the Fuel Level Sensor Float Arm from the "empty" position to the "full" position while observing the Fuel Level Sensor voltage
indications on the Scan Tool EVAP Data Screen.
22.
Confirm that the voltage makes a smooth transition from 0.7 to 2.7 volts.
23.
If the voltage "dips" or "spikes," at any point throughout the voltage range, replace the Fuel Level Sensor.
Fuel Level Sensor Replacement Procedure
Removal
1.
The Fuel Pump Module has a single (in-tank) sub-harness that must be disconnected from the Fuel Pump Module Mounting Flange Connector.
2.
Using a small pair of needle-nosed pliers, remove and retain the secondary terminal lock from the sub-harness electrical connector.
3.
Using a suitable terminal release tool (similar to Snap-on # YA500GM), depress the lock tang for terminals 1 and 6, then pull the terminals out
through the back of the connector.
Note:
The Fuel Level Sensor Terminals have a beveled edge which requires proper orientation when reinstalling in the connector. Carefully note their
location by wire color in the connector prior to removal.
