Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
3. Connect both tie rods to the steering gear by threading the inner tie rod bolts through the inner tie rod plate, the tie rods, and the center housing
cover washers into the rack guide. Install a new lock plate.
Tighten
Tighten the inner tie rod bolts to 90 Nm (66 ft. lbs.).
4. Seat the dash seal and attach the coupling flange to the steering gear. Secure the coupling flange assembly with the top pinch bolt on the coupling
flange assembly.
Tighten
Tighten the coupling flange pinch bolt to 22 Nm (16 ft. lbs.).
5. Tighten all the steering gear retaining bracket nuts and bolts.
Tighten
Tighten the steering gear retaining bracket nuts and bolts to 38 Nm (28 ft. lbs.).
6. Check that the steering gear has remained in the straight-ahead position.
7. Connect negative battery cable.
8. Reconnect the coolant surge tank with the attaching nuts.
Tighten
Tighten the coolant surge tank attaching nuts to 4 Nm (36 inch lbs.).