Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Assembly Procedure
1. Lubricate the O-ring seals with power steering fluid.
2. Place the O-ring seals into the housing. Connect the cylinder lines to the rack and pinion housing.
3. Install the power steering line fittings at the pinion valve end.
Tighten
Tighten the power steering line fittings to 18 Nm (13 ft. lbs.).
4. Install the power steering line fittings at the cylinder end.
Tighten
Tighten the power steering line fittings to 27 Nm (20 ft. lbs.).
5. Install the rack and pinion steering assembly into the vehicle.
Stub Shaft Seals and Upper Bearing
STUB SHAFT SEALS AND UPPER BEARING
-
Tools Required
-
KM-472 Wrench
-
J-36545 Installing Tube
-
J-29810 Stub Shaft Seal Protector
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.
2. Remove the adjuster plug locknut from the adjuster plug using the wrench KM-472.
