Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
7. Using a press, press on the threaded end of the pinion until it is flush with the ball bearing assembly.
Important: The bearing and annulus are pressed together. Disassemble only if bearing replacement is required.
8. Remove stub shaft dust seal, stub shaft seal and stub shaft bearing annulus assembly from valve end of housing.
Assembly Procedure
1. Seat the pinion assembly into the housing.
NOTICE: If the stub shaft is not held, damage to the pinion teeth will occur.
2. While holding the stub shaft, thread the locknut onto the end of the pinion.
Tighten
Tighten the pinion locknut to 30 Nm (22 ft. lbs.).
3. Install the dust cap to the bottom of the housing.