Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Suspension Strut / Shock Absorber: Service and Repair
Shock Absorber
Removal Procedure
NOTICE: Remove only one shock at a time when both shocks are being replaced. Suspending the rear axle at full length can result in damage to
brake lines and hoses.
1. Open the trunk and remove the section of the trim cover covering the upper mount nut.
2. Counterhold the threaded shock absorber shaft and remove the upper mounting nut.
Important: When lifting the vehicle with a body hoist, it will be necessary to support the rear axle with adjustable jack stands.
3. Raise the vehicle and support the rear axle assembly.
4. Remove the lower shock absorber-to-axle nut and the bolt. Remove the shock.
Installation Procedure
Important: It will be necessary to bring the axle assembly to trim height prior to tightening the shock absorber attachment bolts.
1. Insert the lower shock absorber-to-axle bolt through the shock absorber lower attachment bracket and into the axle. Loosely attach the nut.
2. Lower the vehicle enough to guide the upper shock stud through the body opening and loosely install the attaching nut.
Tighten
Tighten the lower shock absorber-to-axle bolt to 70 Nm (52 ft. lbs.).
