Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Shift Linkage: Adjustments
SHIFT LINKAGE ADJUSTMENT
1. Disconnect the negative battery cable.
2. Position the gearshift lever into NEUTRAL.
Important: All the gears must be easy to engage when the vehicle is stationary, the engine is running, and the clutch is disengaged.
3. Loosen the rod clamp bolt.
4. Remove the adjustment hole plug from the shift lever cover.
5. Turn the gearshift rod and fully insert a 5 mm (0.2 inch) gauge pin into the adjustment hole.
6. Remove the boot from the console.
7. Pull the boot upward to expose the shift control lever mechanism.
8. Position the gearshift lever close to the left side of the NEUTRAL position.
