Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
Rear Door Weatherstrip: Service and Repair
Door Seal Trim
DOOR SEAL TRIM
REMOVAL PROCEDURE
1. Remove the door trim panel. Refer to Interior Trim.
2. Remove the screws and the door pull bracket.
3. Remove the door seal trim.
INSTALLATION PROCEDURE
1. Install the door seal trim.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the door pull bracket with the screws.
Tighten
Tighten the door pull bracket screws to 3.5 N.m (31 lb-in).
3. Install the door trim panel. Refer to Interior Trim.
