Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
Mirrors: Service and Repair
Inside Rearview Mirror
The inside rearview mirror is attached to a support which is secured to the windshield glass. The support is installed by the glass supplier using a
plastic-polyvinyl butyl adhesive.
Service replacement windshield glass has the mirror support bonded to the glass assembly. In order to install a detached mirror support or install a new
part, the following items will be needed:
-
Loctite (R) Minute-Bond Adhesive.
-
Original or replacement mirror support.
-
Wax marking pencil or crayon.
-
Rubbing alcohol.
-
Clean paper towel.
-
Fine grit sandpaper (grit #320 or #360).
-
2 mm allen wrench.
INSTALLATION PROCEDURE
1. Measure the distance from the headliner to the bottom of where the mirror support will be mounted on the windshield.
2. Mark this position on the outside of the glass with a wax pencil or crayon. Draw a large diameter circle on the outside of the glass around the
mirror support location.
3. Clean the inside surface of the glass with paper towels and a domestic scouring cleanser, a glass cleaning solution, or a polishing compound. Rub
the glass until the area is completely dry. When the area is dry, clean the area with an alcohol-saturated paper towel in order to remove any traces
