Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
1. Lubricate the new seals with clean brake fluid. Install the seals into the cylinder body.
2. Install the reservoir on the master cylinder body. (The ABS system is shown.)
3. For vehicles with the manual transaxle, connect the clip to the clutch hose connection at the master cylinder.
4. Add brake fluid.
5. Raise and suitably support the vehicle.
6. Bleed the braking system. Bleed the clutch master cylinder.
See: Brake Bleeding
7. Lower the vehicle.
8. Connect the reservoir electrical connector.
