Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
16. Stagger the piston oil rings, the oil ring rail gaps, the second compression ring, and the top compression ring in relation to the notch on the top of
the piston.
17. Lubricate the cylinder wall and the piston rings with clean engine oil.
18. Install the piston using a ring compressor and a wood handle. Guide the lower connecting rod end to prevent damaging the crankshaft journal.
19. Install the connecting rod cap and bearings.
20. Install the connecting rod bearing cap bolts.
-
Tighten the connecting rod bearing cap bolts to 25 Nm (18 ft. lbs.). Using the angular torque gauge KM 470-B, tighten the bolts one turn of
30 degrees plus.
21. Install the oil pump pickup tube.
