Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
Refrigerant Pressure Sensor / Switch: Service and Repair
A/C PRESSURE TRANSDUCER
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Release the connector lock and pull the air conditioning (A/C) pressure transducer wire connector out.
3. Hold the line fitting boss with one wrench and remove the A/C pressure transducer with another wrench.
4. Discard the O-ring seal.
INSTALLATION PROCEDURE
1. Install the new seal on the A/C pressure transducer.
2. Install the A/C pressure transducer.
Tighten
Tighten the pressure transducer (using two wrenches) to 8 N.m (71 lb-in).
3. Install the wire connector.
4. Connect the negative battery cable.
