Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
5. Install the ball joint-to-knuckle/strut nut and the ball joint cotter pin.
Tighten the ball joint-to-knuckle/strut nut to 70 Nm (52 ft. lbs.).
6. Connect the ABS speed sensor electrical connector, if applicable.
7. Connect the brake caliper to the knuckle/strut assembly.
8. Install the wheel.
9. Install a new drive axle-to-hub caulking nut.
Tighten the drive axle-to-hub caulking nut to 180 Nm (133 ft. lbs.).
Loosen the nut and retighten the nut to 50 Nm (37 ft. lbs.). Then tighten the nut an additional 60 degrees.
10. Crimp the caulking nut sleeve onto the drive axle shaft.