Lanos SE Hatchback L4-1.6L DOHC D-TEC MFI (1999)
7. Insert the new retaining ring into the groove in the cylinder bore. (The non-ABS cylinder body is shown.) Remove the welding rod.
8. Move the pistons backward and forward after installation to check for free movement.
9. Lubricate the seal ring and insert the seal on the shaft into the cylinder bore. The open side must face outward until the seal rests on the piston.
10. Install the brake fluid reservoir to the master cylinder.
11. Install the master cylinder assembly.
12. Raise and suitably support the vehicle.
13. Bleed the braking system. See: Brake Bleeding
14. Lower the vehicle.