Lanos SE Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Brake Lamp: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Open the hatchback door.
3. Remove the stop/backup lamp access cover.
4. Remove the nuts and the stop/backup lamp assembly.
5. Disconnect the electrical connector.
Installation Procedure
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the stop/backup lamp assembly with the nuts.
Tighten
Tighten the stop/backup lamp assembly nuts to 3 Nm (27 lb.in).
2. Connect the electrical connector.
3. Install the stop/backup lamp access cover.
4. Connect the negative battery cable.