Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
8. Install the stabilizer shaft-to-stabilizer link nuts. Do not tighten.
Tighten
Tighten the stabilizer shaft clamp bolts to 37 Nm (27 ft. lbs.).
9. Install the crossmember assembly into the vehicle.
10. Lower the vehicle so the control arms are supported by jackstands.
Tighten
Tighten the control arm rear bushing clamp bolts to 75 Nm (55 ft. lbs.).
Tighten the control arm front bushing nuts to 140 Nm (103 ft. lbs.).
Tighten the stabilizer link-to-control arm nuts to 45 Nm (33 ft. lbs.).
Tighten the stabilizer shaft-to-stabilizer link nuts to 45 Nm (33 ft. lbs.).
11. Remove the jackstands and lower the vehicle.
