Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Arm Rest: Service and Repair
Removal Procedure
1. Lower the rear seatbacks.
2. Remove the retaining clips and reposition the rear seatback backside cover.
3. Remove the nuts and the armrest.
Installation Procedure
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the armrest with the nuts.
Tighten
Tighten the armrest nuts to 12 Nm (106 lb.in).
2. Install the rear seatback backside cover with the retaming clips.
3. Raise and secure the rear seatbacks in the upright position.