Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
License Plate Lamp: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the screws and the license plate lamp assembly.
3. Remove the bulb.
Installation Procedure
1. Install the replacement bulb.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the license plate lamp assembly with the screws.
Tighten
Tighten the license plate lamp assembly screws to 2 Nm (18 lb.in)
3. Connect the negative battery cable.
