Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
1. Install new sealing washers at the compressor connecting block end and a new O-ring at the condenser connecting block end.
2. Position the hose into the vehicle, and install the nut at the condenser connecting block.
Tighten
Tighten the discharge hose connecting block-to- condenser retaining nut to 16 Nm (12 lb.ft).
3. Mate the hose connecting the connecting block to the compressor, and install the retaining nut.
Tighten
Tighten the discharge hose connecting block-to-compressor retaining nut to 33 Nm (24 lb.ft).
4. Evacuate and recharge the A/C system.
5. Connect the negative battery cable.
