Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
1. Install the rear wheel speed sensor to the rear knuckle. Secure it with the bolt.
Tighten
Tighten the rear wheel speed sensor bolt to 8 Nm (71 inch lbs.).
2. Connect the rear wheel speed sensor electrical connector.
3. Secure the speed sensor cable into its clamps on the hydraulic pipe.
4. Secure the speed sensor cable grommets into their clamps inside the fender well.
5. Lower the vehicle.
6. Connect the negative battery cable.
Jumper Harness
Removal Procedure
1. Remove the negative battery cable.
2. Raise and suitably support the vehicle.
3. Remove the left front wheel.
4. Remove the wheel well splash shield inside the left front wheel arch to expose the body wiring harness where it enters the engine compartment.