Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
1. Install the Park/Neutral Position (PNP) switch, then install the stud bolt, bolt and nut and washer hand tight.
Tighten
Tighten the retaining nut to 6 - 8 Nm (53 - 71 ft. lbs.).
2. Place the shift control lever in the Neutral (N) position.
3. Align the neutral basic line on the PNP switch with the flat on the manual detent lever.
Tighten
Tighten the stud bolt to 20 - 29 Nm (14 - 22 ft. lbs.).
Tighten the bolt to 10 - 16 Nm (7 - 11 ft. lbs.).
4. Position the fluid filler tube bracket on the stud bolt and the shift control cable linkage on the manual detent lever stud. Install the shift control
cable linkage and fluid filler tube bracket retaining nuts.
Tighten
