Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
8. Separate the knuckle from the ball joint using the ball joint remover KM-333.
9. Remove the nuts from the bolts that connect the knuckle assembly to the strut assembly.
NOTICE: Do not overextend the axle joints. When either end of the shaft is disconnected, overextension of the joint can result in separation of
internal components and possible joint failure. Use drive axle joint seal protectors whenever performing service on or near the drive axles, Failure to
do so can cause internal joint or seal damage and result in possible joint failure.
10. Separate the drive axle shaft from the wheel hub.
11. Support the drive axle.
12. Remove the bolts that connect the knuckle assembly to the strut assembly.
