Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Steering Gear: Service and Repair
Stub Shaft Seals and Upper and Lower Bearing
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.
2. Remove the dust cover from the lower end of the housing.
NOTICE: If the stub shaft is not held, damage to the pinion teeth will occur.
3. While holding the stub shaft with a wrench, remove the locknut from the pinion.
4. With the gear centered, mark the location of the stub shaft notch on the housing to aid in properly installing the valve and pinion assembly.
