Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
6. Install the tie rod end boot retaining clamps.
7. Reposition the adjusting nut to the marks on the inner tie rod and install the outer tie rod by twisting it onto the inner tie rod.
8. Perform a front toe adjustment. See: Alignment
9. Tighten the adjusting nut.
Tighten
Tighten the outer tie rod adjusting nut to 64 Nm (47 ft. lbs.).
10. Install the rack bearing assembly into the rack and pinion steering assembly.
11. Install the valve and pinion assembly into the rack and pinion steering assembly.
12. Install the rack and pinion steering assembly into the vehicle.
Hydraulic Cylinder Lines
Removal Procedure
1. Siphon the power steering fluid from the fluid reservoir.
2. Raise and suitably support the vehicle.
3. Disconnect the power steering gear hydraulic cylinder pipes from the power steering gear at the valve end. Replace the O-ring seals, as needed.
