Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
2. Install the lower valve assembly bearing and the bushing.
3. Center the rack in the housing.
4. Install the the valve assembly, the stub shaft bearing annulus assembly, and a new stub shaft dust seal into the housing.
IMPORTANT: When the valve and pinion assembly is fully seated in the housing, be sure that the notch in the stub shaft and the mark on the
housing line up.
NOTICE: If the stub shaft is not held, damage to the pinion teeth will occur.
5. While holding the stub shaft, install the locknut onto the pinion shaft.
Tighten
Tighten the pinion locknut to 30 Nm (22 ft. lbs.).