Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
1. Pass the harness through the grommet in the floor.
2. Connect the new wheel speed sensor harness to the wheel speed sensor.
3. Secure the connector in its clamp.
4. Adjust the cable length and tape the grommet opening under the vehicle.
5. Lower the vehicle.
6. Tape the grommet opening inside the vehicle.
7. Pass the harness through the grommet and on into the engine compartment.
8. Install terminals onto the harness wires and insert the new terminals into the appropriate cavities of connector C107.
9. Reconnect connector C107 to the ABS harness.
10. Secure the new speed sensor harness into the body wiring harness.
11. Replace the wheel well splash shield.
12. Replace the left front wheel.
13. Lower the vehicle.
14. Connect the negative battery cable.
