Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
Housing Assembly HVAC: Service and Repair
Manual A/C
Heater/Air Distributor Case Assembly
Removal Procedure
1. Disconnect the negative battery cable.
2. Recover the refrigerant. Refer to "Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System" in this section.
3. Remove the nuts that secure the air conditioning (A/C) suction hose and liquid evaporator pipe blocks at the bulkhead.
4. Loosen the A/C suction hose clamp bolt. Loosen the liquid evaporator pipe clamp bolt.
5. Loosen the A/C suction hose and the liquid evaporator pipe clamps to allow movement of the tubes.
6. Pull the A/C suction hose and liquid evaporator pipe from the evaporator inlet.
7. Remove the evaporator drain hose.
