Leganza SX L4-2.2L DOHC D-TEC MFI (1999)
Temperature Sensor (Gauge): Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Drain the coolant to a level below the coolant temperature sensor.
3. Disconnect the electrical connector from the coolant temperature sensor.
4. Remove the temperature sensor from the exhaust gas recirculation (EGR) valve mounting adapter.
INSTALLATION PROCEDURE
1. Install the coolant temperature sensor into the threaded hole in the EGR valve mounting adapter.
Tighten
Tighten the coolant temperature sensor to 20 Nm (115 ft. lbs.).
2. Connect the electrical connector to the coolant temperature sensor.
3. Refill the engine cooling system. Refer to Coolant; Service and Repair.
4. Connect the negative battery cable.