Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Front Door Limiter: Service and Repair
Removal
1. Remove the door trim panel. Refer to Interior Trim.
2. Reposition the door seal trim.
3. Remove the bolts on the door and on the body.
4. Remove the door hold open link.
Installation
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the door hold open link to the door and the body with the bolts.
Tighten
Tighten the door hold open link-to-body bolt to 27 N.m (20 lb-ft).
Tighten the door hold open link-to-door bolts to 6 N.m (53 lb-in).
2. Reposition the door seal trim.
3. Install the door trim panel. Refer to Interior Trim.
