Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Blower Motor: Service and Repair
NOTE: The Position of Heating, Ventilation and Air Conditioning (HVAC) Controller moved upward, but the On-Vehicle Service is similar.
Removal
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to Instrumentation/Driver Information.
3. Remove the footwell upper cover. Refer to Instrumentation/Driver Information.
4. Disconnect the blower motor electrical connector.
5. Remove the blower motor cooling hose.
6. Remove the screws that secure the motor to the heater/air distributor case.
7. Remove the motor, the seal, and the shock mount pads from the heater/air distributor case by gently pulling the motor straight down and out.
Installation
1. Install the blower motor and the seal with the shook mount pads in the heater/air distributor case. Hold the blower motor in position.
2. Install the screws to secure the blower motor to the heater/air distributor case.
Tighten
Tighten the blower motor retaining screws to 6 N.m (53 lb-in).
3. Install the blower motor cooling hose.
4. Connect the blower motor electrical connector.
5. Connect the negative battery cable.
6. Confirm that the blower motor operates properly.
7. Replace the footwell upper cover. Refer to Instrumentation/Driver Information.
8. Replace the glove box. Refer to Instrumentation/Driver Information.