Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
NOTE: To avoid damaging the heater core tubes, make sure they do not contact the fire wall opening.
2. Slowly raise the heater/air distributor case assembly into position and hold it against the fire wall while the screws are installed and tightened from
the engine side of the fire wall.
3. Align and install the heater/air distributor case assembly screws above the fuel filter and at the evaporator flange.
Tighten
Tighten the heater/air distributor case assembly screws to 8 N.m (71 lb-in).
4. Install the heater/air distributor case assembly screws adjacent to the heater hoses.
Tighten
Tighten the heater/air distributor case assembly screws to 8 N.m (71 lb-in).
5. Install the evaporator drain hose.
6. Install the two heater hoses.
7. Slide the heater hose clamps into position.
8. Install the instrument panel carrier assembly.
