Nubira SE Sedan L4-2.0L DOHC D-TEC MFI (2001)
Front Door Interior Handle: Service and Repair
Removal Procedure
1. Remove the door seal trim. Refer to "Door Seal Trim".
2. Remove the screw securing the door handle to the door.
3. Slide the door handle forward and remove it from the door.
4. Disconnect the inside door handle and the lock rods.
Installation Procedure
1. Connect the inside door handle and the lock rods.
2. Insert the inside door handle into the slots in the door.
3. Slide the door handle rearward.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
4. Install the inside door handle screw.
Tighten
Tighten the inside door handle screw to 1.5 N.m (13 lb-in).
5. Install the door seal trim. Refer to "Door Seal Trim".