Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Installation Procedure
1. Install the glass in the door and position the glass within the window regulator.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the glass screws.
Tighten
Tighten the glass screws to 4.5 Nm (40 lb.in).
3. Install the exterior B-pillar molding.
4. Install the door seal trim.
Inside Rearview Mirror
The inside rearview mirror is attached to a support which is secured to the windshield glass. The support is installed by the glass supplier using a
plastic-polyvinyl butyladhesive.
Service replacement windshield glass has the mirror support bonded to the glass assembly. In order to install a detached mirror support or to install a
new part, the following items will be needed:
-
Loctite Minute-Bond Adhesive.
-
Original or replacement mirror support.
-
Wax marking pencil or crayon.
-
Rubbing alcohol.
-
Clean paper towel.
-
Fine grit sandpaper (grit #320 or #360).
-
2 mm allen wrench.
Installation Procedure
