Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Tighten
Tighten the passenger assist handle screws to 3.5 Nm (31 lb.in).
2. Install the plastic caps over the assist handle screws.
Interior Courtesy Lamp/Power Sunroof Control Switch
Removal Procedure
1. Disconnect the negative battery cable.
2. Pry off the lamp lens.
3. Remove the screws and the lamp/power sunroof control switch.
4. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
2. Install the lamp/power sunroof control switch with the screws.
Tighten
Tighten the lamp/power sunroof control switch screws to 4 Nm (35 lb.in).
3. Install the lamp lens.
4. Connect the negative battery cable.