Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
11. Attach a transparent tube over the bleeder valve. Allow the tube to hang submerged in brake fluid in a transparent container.
12. Slowly push and hold the brake pedal one time.
13. Loosen the bleeder screw to purge the air from the cylinder.
14. Slowly release the brake pedal. Wait 15 seconds before proceeding with the next step.
Important: Rapid pumping of the brake pedal pushes the master cylinder secondary piston down the bore in a manner that makes it difficult to
bleed the system.
15. Repeat the sequence, including the 15-second wait, until all the air is removed. It may be necessary to repeat the sequence 10 or more times to
remove all the air.
16. Tighten the bleeder valve and replace the dust cover.
Tighten
Tighten the bleeder valve to 6 Nm (53 inch lbs.).
17. Proceed to bleed the brakes following the appropriate sequence, beginning with step 11.
18. Check the brake pedal for sponginess. Repeat the entire bleeding procedure to correct this condition.
