Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Assembly Procedure
WARNING: Keep alcohol and brake fluid away from the eyes, as serious injury may result
CAUTION: Keep rubber seals and brake parts away from oil. Oil can cause the seals to swell and deteriorate, and the braking system could become
inoperative.
Important: Do not use a hone or any other procedure to remove material from the piston or caliper bore.
1. Clean all parts with denatured alcohol or brake fluid. Dry the parts with unlubricated compressed air, and blow out all passages in the caliper and
the bleeder valve.
2. Inspect the piston and the caliper for scoring and corrosion. Replace any components that show these conditions.
3. Insert the bleeder valve and the dust cover.
Tighten
Tighten the bleeder valve to 11 Nm (97 inch lbs.).
4. Lubricate the new inner seal and the caliper bore with brake fluid.
5. Install the inner seal into the groove in the caliper bore.
