Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Brake Master Cylinder: Service and Repair
Disassembly and Reassembly
Disassembly Procedure:
1. Remove the master cylinder.
2. Remove the Brake Fluid Reservoir.
3. Remove the seal ring from the cylinder bore.
NOTICE: When removing the retaining ring, avoid damaging the piston or the cylinder wall.
Important: A welding rod or its equivalent can be used in a compensating port to keep the piston pressed.
4. Remove and discard the retaining ring from the cylinder body (the non-ABS master cylinder body is shown) using a suitable screwdriver.
5. Remove the primary piston (the ABS master cylinder body is shown).
6. Carefully remove the secondary piston assembly, including the springs, from the master cylinder bore.