Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
2. Remove the motor pack from the hydraulic modulator/motor pack assembly.
NOTICE: Do not allow the gear to turn while removing the retaining nut, since the modulator piston can hit the top of the modulator bore,
damaging the piston. Turn the modulator gear to position the piston in the center of its travel. Place a screwdriver through the holes in the gears
(not between the gears) into the recessed hole in the modulator base. This will prevent the gear from turning, aiding in gear removal.
3. Remove the retaining nut holding the gear(s) being replaced.
4. Remove the gear(s).
Assembly Procedure
NOTICE:
-
Do not allow the gear to turn while installing the retaining nut. Turn the modulator gear to position the piston in the center of its travel. Place a
screwdriver through the holes in the gears (not between the gears) into the recessed hole in the modulator base. This will prevent the gear from
turning, aiding in gear removal.
-
Install the gears in the same location they were in before removal.
Important: Do not lubricate or oil the gears on the motor pack.
1. Install the gear(s) onto the hydraulic modulator.
2. Secure each gear with one nut.
Tighten
Tighten gear nuts to 8.5 Nm (75 inch lbs.).
3. Install the motor pack to the hydraulic modulator.
4. Install the hydraulic modulator/motor pack assembly to the vehicle.
