Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
1. Install the front wheel speed sensor to the steering knuckle. Secure it with the bolt.
Tighten
Tighten the front wheel speed sensor bolt to 7.8 Nm (69 inch lbs.).
2. Connect the front wheel speed sensor electrical connector.
3. Replace the wheel.
4. Lower the vehicle.
5. Connect the negative battery cable.
Wheel Speed Sensor Jumper Harness
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the electronic brake control module (EBCM) from its retaining clamp.
3. Disconnect connector J1 (24-pin connector) from the EBCM.
4. Remove the appropriate terminals from connector J1:
-
Right side - terminals B3 (BRN) and A4 (DK GRN).
-
Left side - terminals B4 (YEL) and A5 (LT BLU).
5. Open the wiring harness that passes through the fire wall. Both speed sensor harnesses break out just inside the engine compartment. The
right-side speed sensor harness crosses the top of the fire wall to the right-side fender area. The left-side speed sensor harness goes directly to the
left-side fender area.
6. Free the speed sensor harness from the wiring harness.
7. Raise and suitably support the vehicle.
8. Remove the wheel.
9. Turn the steering wheel to expose the speed sensor. It is located at the rear of the steering knuckle near the tie rod end.
