Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Installation Procedure
1. Install the rear wheel speed sensor to the hub carrier. Secure it with one bolt.
Tighten
Tighten the rear wheel speed sensor bolt to 7.8 Nm (69 inch lbs.).
2. Connect the rear wheel speed sensor electrical connector.
3. Replace the harness cover over the speed sensor harness and the forward suspension arm.
4. Secure the harness cover and the connector to the suspension arm with a new cable tie.
5. Lower the vehicle.
6. Connect the negative battery cable.
Wheel Speed Sensor Jumper Harness
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
