Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
fan assembly must be replaced with a new fan assembly. It is essential that fan assemblies remain in proper balance. A fan assembly that is not in
proper balance can fail and fly apart during use, creating extreme danger. Proper balance cannot be assured on a fan assembly that has been bent or
damaged.
1. Install the fan motor to the shroud.
2. Secure the motor to the shroud with the retaining screws.
Tighten the fan motor retaining screws to 4 Nm (35 inch lbs.).
3. Turn over the fan shroud assembly.
4. Install the fan to the fan shroud assembly with the single nut in the center of the fan hub.
Tighten the fan motor nut to 3.2 Nm (28 inch lbs.).
5. Install the fan shroud assembly to the radiator.
Important: Be careful to seat the mounting post on the fan shroud into the socket at the radiator left tank. Be sure to slip the tab at the bottom
edge of the shroud into the retaining clip near the center of the radiator.