Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
11. While holding the intake camshaft firmly in place, remove the intake camshaft gear bolt.
12. Remove the intake camshaft gear.
13. While holding the exhaust camshaft firmly in place, remove the exhaust camshaft gear bolt.
14. Remove the exhaust camshaft gear.
Installation Procedure
Notice: Take extreme care to prevent any scratches, nicks or damage to the camshafts.
1. Install the intake camshaft gear.
2. While holding the intake camshaft firmly in place, install the intake camshaft gear bolt.
Tighten the intake camshaft gear bolt to 50 Nm (37 ft. lbs.).
3. Install the exhaust camshaft gear.
4. While holding the exhaust camshaft firmly in place, install the exhaust camshaft gear bolt.
Tighten the exhaust camshaft gear bolt to 50 Nm (37 ft. lbs.). Using the angular torque gauge KM-470-B, tighten both the intake and the exhaust
camshaft gear bolts another 60 degrees plus 15 degrees.
5. Apply a small amount of gasket sealant to the corners of the front camshaft caps and to the top of the rear valve cover-to-cylinder head seal.
6. Install the valve cover and the valve cover gasket.
7. Install the valve cover washers.
