Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Installation Procedure
1. Apply a small amount of gasket sealant to the corners of the front camshaft caps and the top of the rear valve cover-to-cylinder head seal.
2. Install the new valve cover gasket to the valve cover.
3. Install the valve cover.
4. Install the valve cover washers.
5. Install the valve cover bolts.
Tighten the valve cover bolts to 8 Nm (71 inch lbs.).
6. Connect the camshaft position sensor.
7. Connect the ignition wires to the spark plugs.
8. Install the spark plug cover.
9. Install the spark plug cover bolts.
Tighten the spark plug cover bolts to 3 Nm (27 inch lbs.).
10. Connect all of the necessary vacuum lines.
11. Connect the breather tube to the valve cover.