Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
1. Position the high pressure pipe into the vehicle.
2. Install a new O-ring on the pipe at the receiver-dryer
3. Install the high pressure pipe-to-receiver-dryer connecting block nut.
Tighten
Tighten the high pressure pipe-to-receiver-dryer connecting block nut to 10 Nm (89 lb.in).
4. Install the the high pressure pipe-to-evaporator flange connecting block nut.
Tighten
Tighten the high pressure pipe-to-evaporator flange connecting block nut to 10 Nm (89 lb.in).
5. Install the bolts which secure the clamps that hold the high pressure pipe to the vehicle.
Tighten
Tighten the clamp bolts to 4 Nm (35 lb.in).
6. Connect the electrical connector to the pressure transducer.
7. Install the air cleaner housing assembly with the retaining bolts.
Tighten
Tighten the air cleaner housing assembly retaining bolts to 12 Nm (106 lb.in).
8. Connect the negative battery cable.
9. Evacuate and recharge the A/C system.
