Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
1. Install a new O-ring seal onto the suction hose end at the evaporator flange.
2. Position the hose assembly and the support clamp in place in the vehicle.
3. Insert the suction hose end into the evaporator flange.
4. Install the evaporator flange connecting block retaining nut.
Tighten
Tighten the evaporator flange connecting block retaining nut to 10 Nm (89 lb.in).
5. Install new sealing washers onto the pilots of the suction/discharge block fitting. The washers must be seated against the surface of the block
fitting.
6. Mate the hose connecting block to the compressor. Hold it in place while tightening the retaining nut.
Tighten
Tighten the discharge hose connecting block-to- compressor retaining nut to 33 Nm (24 lb.ft).
7. Install the suction hose support clamp on the left-side strut tower and tighten the support clamp retaining nut.
Tighten
Tighten the suction hose support clamp retaining nut to 5 Nm (44 lb.in).
8. Install the suction hose support clamp along the left side of the engine compartment fender well.
Tighten
Tighten the suction hose support clamp retaining bolt to 5 Nm (44 lb.in).
