Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Wheels: Description and Operation
WHEELS
Wheels must be replaced if they are bent, dented, have excessive lateral or radial runout, leak air through welds, have elongated bolt holes, or if the
wheel bolts will not stay tight or are heavily rusted. Wheels with excessive runout may cause vehicle vibration. Replacement wheels must be
equivalent to the original equipment wheels in load capacity, diameter, rim width, offset, and mounting configuration. A wheel of improper size or
type may affect wheel and bearing life, brake cooling, speedometer/odometer calibration, vehicle ground clearance, and tire clearance to the body and
the chassis. The wheel offset is 49 ± 1 mm (1.93 ± 0.04 inches). Steel wheels may be identified by a two- or three-letter code stamped into the rim
near the valve stem. Alloy wheels should have the code, the part number, and the manufacturer ID cast into the back side.