Nubira SX Hatchback L4-2.0L DOHC D-TEC MFI (1999)
Alternator: Service and Repair
Removal and Installation
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the intake air temperature (IAT) sensor electrical connector from the air intake tube.
3. Remove all the clamps from the air intake tube hose, and set aside the tube.
4. Raise and suitably support the vehicle.
5. Disconnect the harness connector from the back of the generator.
6. Remove the accessory drive belt by lowering the vehicle and turning the automatic pensioner roller bolt clockwise to relieve tension on the belt.
7. Push up the power steering reservoir and set it aside.
